The standard taper of pin is...............
a) l:40
b) 1:50
c) 1:20
d) 1:30
The included angle for the V belt is usually in degrees ..............
a) 30 to 40
b) 60 to 80
c) 10 to 20
d) 20 to 30
The size of gear is usually specified by................
a) Circular pitch
b) PCD
c) Pressure angle
d) Diametrical pitch
For shaft in parallel and rotating in same direction the belt drive used...................
a) Diagonal
b) None of these
c) Open
d) Cross
When close the pipe end is required fitting of................
a) Socket
b)Tee
c) Plug
d)Cap
a) l:40
b) 1:50
c) 1:20
d) 1:30
The included angle for the V belt is usually in degrees ..............
a) 30 to 40
b) 60 to 80
c) 10 to 20
d) 20 to 30
The size of gear is usually specified by................
a) Circular pitch
b) PCD
c) Pressure angle
d) Diametrical pitch
For shaft in parallel and rotating in same direction the belt drive used...................
a) Diagonal
b) None of these
c) Open
d) Cross
When close the pipe end is required fitting of................
a) Socket
b)Tee
c) Plug
d)Cap
No comments:
Post a Comment