TURNER SEMESTER II ITI QUESTION

On which part of the Vernier bevel protractor, are the main scale divisions graduated?
a) Blade
b)Disc
c)Dial
d) Stock

The size of a Vernier height gauge is specified by...........
a) Weight of the height gauge
b) Size of the scriber
c) Height of the beam
d) Width of the beam

Which one of the following thread forms is provided on thread shafts, whose thread pitch is
expressed in module?
a) Buttress thread   
b) Worm thread     
c) Saw tooth thread 
d) Knuckle thread

The taper per foot of BS 10 self-holding taper is...............
a) 0.5161 per foot   
b) 0.5611 per foot   
c) 0.6151 per foot   
d) 0.611 per foot

Which one of the following angles is not ground on a form tool?
a) Front clearance angle
b) Rake angle
c) Side clearance angle
d) Relief angle

The graduations are marked at the base of the tail stock. To offset the body these graduations
are given in.........
a) Degrees
b)mm
c) Taper per foot   
d) Radians

Which of the following combination of change of gears required when the pitch of a lead screw is 6 mm and the pitch of the thread to be cut is 1.25mm?
a) Driving gears 40 & 120 and Driven gears 50 & 20
b) Driving gears 50 & 120 and Driven gears 40 & 20
c) Driving gears 50 & 20 and Driven gears 40 & 120
d) Driving gears 40 & 20 and Driven gears 120 & 50